                       Mouse Driver Installation
                       FOR MICROSOFT WINDOWS 3.0

------------------
1. INTRODUCTION
------------------

  The following instructions are applicable to the users who use
  Amouse in Microsoft Windows 3.0 environment.

  This Amouse diskette contains three files listed below for
  Microsoft Windows 3.0 application.

          WINDOWS.TXT - this file
          SETUP.INF   - the Information file for the SETUP.EXE of Windows 3.0
                        to install drivers and virtual devices
          AMOUSE.DRV  - Mouse driver for Windows 3.0


  AMOUSE.DRV can support three kind of mouse:

          A. Microsoft Serial Mouse, which supports the use of two buttons.
          B. Bus Mouse
          C. PS/2 Mouse

  It is fully compatible with the mouse driver (MOUSE.DRV) provided by
  Microsoft Windows 3.0 itself. Therefore, you can use mouse with
  MOUSE.DRV instead of AMOUSE.DRV if you prefer MOUSE.DRV. Furthermore,
  you can use mouse and select "Mouse System (or VisiOn) connected
  to COM1:" or "Mouse System (or VisiOn) connected to COM2:" when you run
  SETUP in Windows 3.0 because the mouse also can be used as Mouse
  System type mouse which supports three buttons. But you know there are
  few Windows 3.0 specific applications using the middle button.


------------------------------------------------------------
2. PROCEDURE FOR INSTALLING WINDOWS 3.0 AT THE FIRST TIME
------------------------------------------------------------

  1. Make a copy of your Windows 3.0 Setup diskette.

  2. After the copy being made, return the original to its jacket and
     store safely.

  3. Copy the file SETUP.INF contained in the Mouse diskette
     to the newly-created copy of the Setup diskette.

  4. Type SETUP [ENTER] to begin installation of Windows 3.0.

  5. Review the configuration list when it is shown. If you wish to
     change Mouse type, move the cursor (highlighted line) to the
     "Mouse:" line and press [ENTER] to select from the available
     list.

  6. The program will ask you to insert the Mouse Diskette
     in order to install AMOUSE.DRV as required if you select
     Mouse. After this is done, the installation program will
     continue normally.

  After you complete the above steps, the mouse driver is installed
  and you can begin to use Windows 3.0 with mouse.


-------------------------------------------------
3. PROCEDURE FOR WINDOWS 3.0 ALREADY INSTALLED
-------------------------------------------------

To use the mouse driver for Windows 3.0 you need to copy the
following files into the your \WINDOWS\SYSTEM subdirectory.

        AMOUSE.DRV
        SETUP.INF


After the copying, you have two methods to change the mouse configuration.
First, you can run Windows SETUP under DOS and select the Amouse in
the mouse configuration. Second, you can use Windows Setup within Windows
itself and select the Amouse in the mouse configuration. See the
Microsoft Windows User's Guide for further more information.
